![]() You can then select the audio device you wish to capture audio from - select it under ‘Live Recording’.You must also make sure there is music playing in Winamp. If you are unable to connect, go back to step 4 and double check every server setting.If it’s working properly, a numeric value will appear indicating the transmission speed. You should see information about the encoder status in the ‘Transfer Rate’ column.(16) Hilite the new encoder, then click the ‘Connect’ button.Too many things changed between DSP-Quattro v5 and its previous versions, it was impossible to keep the compatibility. Q: Can DSP-Quattro v5 load projects or AudioCDLayouts saved by previous versions of DSP-Quattro A: NO, it can’t. In the ‘YP Settings’ section, enter your station details. These applications use a built-in internal mp3 encoder to export as mp3. ![]() (14) (Icecast2 only) Enter the mount point - this will usually be /stream by default for Fast Serv Icecast2 servers.(13) Enter the DJ or Admin password of your server.(12) Enter the port number of your server.(11) Enter the host name of your server.(10) Select ‘Icecast2’ for Icecast server, or ‘Shoutcast’ for Shoutcast server.(8) Number of channels - Enter 2 for bitrates above 48, choose 1 for bitrates below 48.(7) Enter your samplerate - Enter 44100 for bitrates above 96, or 22050 for streams below 96.(6) Enter your chosen bitrate - this must be equal or lower than the rate you purchased.In the ‘Basic Settings’ section, set up the encoder. (5) Choose ‘Configure’ from the menu that appears.(4) Right-click the new encoder that appears below it. ![]() Step 3 - Start Edcast Standalone and configure the encoder It is VERY important that you save this file inside the actual Edcast program folder.
0 Comments
Leave a Reply. |